Reanibex 800

The Reanibex 800 has a revolutionary system that allows the defibrillator monitor to be adapted and customised to the user’s needs at any time.
The Reanibex 800’s modules have a built-in plug & play system that allow expansion and updating with new functionalities, without sending the unit to the factory. This ensures that the unit is always available for use.

AED MODE:

In AED mode, the device analyses the ECG signal, and performs the defibrillation if necessary, guiding the user throughout the intervention
protocol. The Reanibex 800 provides audio prompts and on-screen instructions as well as providing CPR guidance. It has a built-in metronome to guide the rescuer in achieving the correct rate while performing compressions, and an indicator to provide information about the cardiac massage quality..

MANUAL MODE:

If the user selects Manual Mode, then the user controls the whole defibrillation procedure, and the Reanibex 800 provides no indications about whether a shock is required or not. Manual mode is suitable for manual defibrillation, synchronised cardioversion and vital signs monitoring.

NON-INVASIVE PACEMAKER:

A non-invasive transcutaneous pacemaker is a device that delivers electrical stimulation to the heart, thus triggering cardiac depolarisation and contraction of the myocardium. Pacemaker pulses are delivered only using disposable multifunction electrodes, both adult and paediatric.

MONITOR MODE:

This mode is suitable for monitoring vital signs obtained from the pulse oximetry module and the non-invasive blood pressure module, and acquisition and non-simultaneous monitoring with up to 12 leads.

ECG MONITORING:

For ECG and arrhythmia monitoring, the Reanibex 800 can acquire the waveforms by:

• Monitoring electrodes and 3, 5 or 10-leadwire patient cable
• Multifunction defibrillation electrodes
• Reusable external paddles.

MASIMO® PULSE OXIMETRY:

Pulse oximetry is a continuous, non-invasive method of measuring arterial blood oxygen saturation (SpO2) and pulse rate (PR). The measurement is obtained by placing a sensor on the patient, usually on the fingertips or earlobe for adult patients, and on the hand or foot for neonatal patients.
The sensor is connected to the equipment by a patient cable. The sensor captures the patient’s data signal and sends it to the unit.

SUNTECH® NON-INVASIVE BLOOD PRESSURE

The Reanibex 800’s non-invasive blood pressure module uses oscillometric measurement. This method is non-invasive and measures arterial blood pressure by monitoring the magnitude of pressure changes in the cuff during deflation.

ORIDION MICROSTREAM® CAPNOGRAPHY

The Reanibex 800 capnography module continuously measures the amount of CO 2 in each breath and shows the amount present at the end of exhalation and the airway respiratory frequency rate.

Presión invasiva de Medlab®

El módulo de presión invasiva (PI) del Reanibex 800 ofrece dos canales de las mediciones de presión continua en tiempo real y las formas de onda en los modos Monitor, Desfibrilador Manual y Marcapasos.

MEDLAB® INVASIVE BLOOD PRESSURE®

The Reanibex 800’s invasive blood pressure (IP) module has two channels for real-time continuous pressure measurements and waveforms in Monitor, Manual Defibrillator and Pacemaker modes.

UNIVERSITY OF GLASGOW INTERPRETIVE ALGORITHM

The Reanibex 800 provides automatic analysis of the ECG, using the University of Glasgow algorithm. This algorithm is capable of diagnosing all commonly recognised ECG abnormalities such as myocardial infarction (MI), including severe MI, ventricular hypertrophy, abnormal ST- T changes, and common rhythm abnormalities. It also reports conduction disorders and other anomalies, such as extended QT interval.